Installation recommendations
1. Temperature regulators are dimensioned for boiler operation.
2. The controller must be installed by a qualified person.
3. The controller must be mounted in a place where it is not possible to heat more than 40 degrees C.
4. Installation must be done in accordance with the MONTAJ instructions.
5. The controller should not be subject to direct water action or environmental conditions that may cause condensation (eg gross temperature variations).
6. The appliance must be installed and used in accordance with the rules for the use of electrical appliances.
7. The warranty does not cover damages caused by fuse failure due to an incorrect connection of the pump cables.
8. Check the regulator settings before commissioning the boiler.
9. The controller has 2 fuses (1.25 A).
THE SENSOR is mounted dry (ie without oil).
The connection to the pump network cables and the replacement of the fuses is done only after the controller has been disconnected from the power supply (remove the mains plug from the mains). Otherwise, there is a risk of electric shock.