Română English
 
 
CLIENT SUPPORT
TEL: +40.730.411.277
        +40.786.950.250
Our products
Our products
NEWSLETTER
ADD EMAIL ADDRESS

Noise in the boiler, cold areas in radiators, boiler efficiency or thermal installations is low?

Home » Blog » Noise in the boiler, cold areas in radiators, boiler efficiency or thermal installations is low?
 
Noise in the boiler, cold areas in radiators, boiler efficiency or thermal installations is low?
2018-02-27

 

We have talked about this and we have often tried to emphasize that the purchase of any system is not enough to ensure optimum performance over time. It is well known that for the boilers, solid fuel boilers, sanitary facilities and much more, the initial investment is not small. We generally want to have quality goods with minimum investment, which we are aware of is not possible if we really want something of a higher quality.

 


Returning to the purchase of goods, an important aspect to ensure that any facility is to function in the long run is to maintain it. To keep it in good working order and operate at maximum efficiency, it is necessary to clean and properly wash a system. Additionally, treatments with additives to protect them from corrosion and deposits are indicated. The better the system is at full capacity, the more you can save more resources.

 

Why you should take care even though you bought a new system

 

 

If you think you've purchased a new system and it's not a problem, it might not be the best approach. Why? Because it can not be 100% sure that they are perfectly clean. Precisely at manufacturing, they can inevitably contain contaminants and residues, or they may also be due to system installation work. Indeed, a new system does not compare to an older one, but this probability must not be eliminated.

 


As for older systems, these in most cases have large accumulations of dirt. The type, the size of the waste and the dirt are greatly influenced by system maintenance and age. However, we all talk about this much in the article The importance of chemical washes and the positive effects on our installations.

 

articolul

Termo Protect
This is a super-concentrated antifreeze antifreeze based on monoethylene glycol, which provides the frost-free protection of thermal circuits. The product is suitable for use in any heating system operating at a maximum temperature of 102 ° C, allowing an increased ratio of water dilution depending on the desired operating regime.

 
Corrosion inhibitors and pH stabilizing additives to which they are treated. In short, it optimizes the protection of the materials from which the circuit components are made (copper, iron, stainless steel, brass, rubber, etc.) and ensures proper operation of the circulation pumps in the plant. The antifreeze is intensely colored to be an indicator of toxicity in case of accidental entry into the DHW circuit.

 
Way of ussage
The product should only be used in dilution with demineralized water. Recommended dilution ratios (volume vol.: Vol. Water) *:
 
- 3: 2 dilution, provides protection at -44 ° C
- 1: 1 dilution, provides protection at -36 ° C
- 2: 3 dilution, provides protection at -26 ° C
- 1: 2 dilution, provides protection at -20 ° C

 

It does not contain amines, nitrites, silicates, borates and phosphates. These are compounds that are forbidden by European environmental legislation. To learn more about how to use it, specifications for it, go to the product page.

 

Vezi produsul aici

On the other hand, we have another product as an example, which is part of another product category for chemical washes. As I have already mentioned, we have a wide range of products that would help clean up deposits and misery from the thermal and not only. But today, we refer to the two most used products in these categories, so the second is Cleanex Gudron.

Cleanex Gudron
Disinfectant solution dedicated to the cleaning of tar and non-combustible soot deposited on the walls of combustion chambers of installations using solid fuel (wood, coal, pellets, etc.). The product dissolves tar deposits up to 1mm and is recommended for gasification boilers.

 


Way of ussage
In the cold combustion chamber, it is sprayed directly on the metal, glass, ceramic cleaning surfaces. Allow the product to work for a few minutes, and after soaking the deposits, remove them. To clean combustion chambers with irregular geometry or with a thicker layer of tar, it is recommended to use GUDRONEX beforehand.

 

Vezi produsul aici

Of course, this category includes many more products for cleaning and maintenance of installations. We briefly presented only two of them. Concluding everything, it is extremely important to maintain facilities and products for better long-term operation. Choose quality in relation to price.

NEWSLETTER
ADD EMAIL ADDRESS
Latest news
The process behind coring and its benefits
Firm info
SERVI THERM SAT SRL

Bulevardul Cetatii,Nr. 25 B
Timisoara, Timis
TEL
+40.730.411.277
Email:
info@servitherm.ro
vanzari@servitherm.ro
Copyright © 2024 Servi Therm Sat, Timisoara. All rights reserved